So with some lovely help from Shawn Hendriks at Autodesk I’ve managed to remove the glossy reflection noise from my renders that I talked about in my last post. Somehow in the process I have introduced a whole host of new artifacts… The latest is in the form of crawling bumps.
Before I take a look at the bump issue, here’s how the glossy reflections worked out… At first I thought it was being caused by using a blend material to mask between a rusty material and the mental ray architectural brass looking material, but after simplifying this into just one simple mental ray architectural material the noise was still apparent. So I went back to increasing the ‘glossy reflections precision multiplier’ to around 8 and the antialiasing settings as the solution. This obviously left me with huge render times once again. To try and get these times down I’ve tried a number of optimizing methods but generally I’ve been introducing more artifacts than what I had started with. The problem when testing this at a lower resolution is identifying what artifacts are going to stick around once the final render settings are applied and what will be fixed with a higher resolution render.
I tried to simplify the material by using the ‘Highlights and FG only’ parameter but haven’t been able to achieve the right kind of look for the materials. I have loads of reference imagery and objects to work to, and even though the reflections are mainly highlights unless you are looking at a surface almost from a perpendicular angle, using highlights only in the material doesn’t seem to look quite right.
After reading a bit more I learnt that using the ‘fast glossy interpolation” parameter wasn’t really to be used with highly curved objects or materials with a bump map. I had been using this set of parameters to reduce render times also but still been able to achieve the right look on the single renders.
Actually… I can’t really be bothered to go type any more about this, probably because it’s boring. In the end everything will look fine I’m sure.

Leave a comment